REISSUE SEATS: I am sorry to announce that my "Factory Made" seat lineup is no longer available until further notice. I am still making my "Hand Made" seats and seat kits, pricing and info is below.

These are made with the original Persons tooling. All have welded-on reflector tabs! *** each These re-issue seats are very nicely tucked and do have the correct 'arch' like the original seats. The stripe twists and seat appearance are exactly like the OEM seats that Schwinn supplied when our beloved Sting-Rays were built. These are sold outright, no core required.

These Production seats are made just like the originals. They have crooked stripes, little folds etc. Remember, the holes and tags are hand punched. by eye, and they are more than likely uneven. They always were. Over the years, I have disassembled THOUSANDS of seats and I have yet to see a perfect one. If you are very picky, order one of my Hand-Made seats below. Remember, my Hand-Made seats look better, but the production seats are more correct.

Regarding Chrome Mylar on ribbed seats: Vinyl stretches, Mylar does not. On a hot day, with an adult on a Chrome Mylar seat, sometimes the Mylar will release. The original 60's-70's seats did this and so do these occasionally. If you are building a rider, I'd recommend going with a seat without the Chrome. If you already have a seat that has peeling Mylar, you can remove it with a hairdryer and some patience or carefully tack it back into place with some hobby store super-type glue. The Chrome Mylar seats are best for display use.

Grey Ghost Apple Krate 68 Apple Krate 68 Orange Krate 68 Lemon Peeler Pea Picker Grape Krate Coal Krate (charcoal glitter w/black stripe) Cotton Picker

Ribbed with Chrome Inlay: Silver Glo, Red Glitter, Blue Glitter, Green Glitter, Violet Glitter

REISSUE SEATS: I am sorry to announce that my "Factory Made" seat lineup is no longer available until further notice. I am still making my "Hand Made" seats and seat kits, pricing and info is below.

Hyper-Formance Seat Kits include: Foam, rear seat tag, seat tag rivets, rear seat hardware and grommets/bushings as required, "For One Rider, Not For Two"/"Persons" tags for the underside, cover and instructions.

Recover Installation needed: spray can of 3M 77 (or equivalent) adhesive, bottle of contact cement and 4 rubber-tipped woodworker's clamps. Additional clamps are also available (I use 20 when I build seats...)

**Hand Made Seats are AVAILABLE once again!! After surgery, and a couple-three months of therapy, I am once again making my hand-made seats! Modern Doctors are pretty Kool!

Cotton Picker Correct Glossy-White Vinyl, a Hyper-Formance Exclusive!

1969-up Orange Krate Not correct color, but looks good, a Hyper-Formance Exclusive!

Supply of NOS Pea Picker vinyl is exhausted. Pea Picker seats are made with the current green glitter Zodiac vinyl. It does not match the original color.

Hand-Made Seat Recover, Exchange with Your Core $100.00, Manta's $110.00
On my Sting-Ray/Krate core $140.00

I am reproducing seats on an exchange basis. I need your clean core, no hardware, foam, covering...just the two metal pans with no structural damage, no major rust, no cracks. Call for details. Turnaround time is 2-5 weeks.	Hand Made Seats are $100.00 each with your core. Complete seat INCLUDING core $140.00, Except Manta/Solo Polo


NOS Sunset Orange on the left, my Orange on the right: Mine looks good on Kool or Sunset Orange bikes.	NOS Campus Green on left, Current green on right: The current green is "different".